Three Stage Table Pedestal
Add a table to your patio, deck, RV or boat with ease. This is a non-removable table pedestal set. All you need to do is add your table and you are ready. This unit works with all the "Springfield" table tops.
Operates on a Gas Cylinder, loosen clamps to raise to desired height, tight clamps to hold that height. To lower, loosen clamps and press firmly on the table mount to lower, tighten clamps.
Low Position: 14"
Middle Position: 20"
Highest Position: 28"
(can be locked into any position between the lowest and highest position available)
Post Finish: Polished
Post Diameter Sections: Bottom: 4" Middle: 3.5" Top: 2.875"
Post Wall Diameter: .120"
Base Finish: Polished
Base Diameter: 12"
Hole Pattern: 11"
Mounts easily to most tables
Table Mounting Bracket: 12" X 12"
Load Capacity: 120 lbs Static (anything more than 50 lbs will need manual assist to lift)
Weight of unit 12.5 lbs
Problems adjusting unit:
If unit will not adjust make sure clamp releases from the post when clamp is opened. If it appears to be stuck use a screwdriver and gently pressure it loose.
If unit is adjusting slowly when clamps are open check that the screw on the end of the clamp is not too tight